-
Five general plastics of Jiangmen engineering plastics
2020-11-25 1682
The five internationally used engineering plastics are polyamide (PA), polycarbonate (PC), Polyoxymethylene (POM), polyphenylene oxide (PPO) and thermoplastic polyester (PBT) Engineering plastics can
-
In what modern fields have thermoplastic elastomers been used
2020-10-16 1480
Thermoplastic elastomer is a new type of synthetic material. Its special performance has far exceeded that of the same type of material known from nature. At the same time, its cost has been greatly r
-
Why should modified nylon be used in automobile intake manifold
2020-08-21 1316
The automobile intake manifold is the intake pipe from the rear of the carburetor or throttle body to the front of the cylinder head intake port. Its main function is to distribute the air and fuel mi
-
Causes of warpage and deformation of Jiangmen engineering plastics
2020-07-09 1246
Warping deformation is one of the common defects in injection molding of thin shell plastic parts, because it involves guessing the amount of warping deformation, and the warping deformation rules of
-
Properties of thermoplastic modified plastics
2020-06-03 1353
The molecular weight of polymers in general thermoplastic modification can reach hundreds of thousands to millions, and the length of macromolecular chain can reach 10 ^-3mm. These macromolecules can
-
Application of modified PBT engineering plastics in coil framework field
2020-04-21 1395
"Inductance coil is widely used in the electrical industry." resistance to high frequency and connection to low frequency "is the main feature of inductance coil. High frequency signal will encounter
-
Molding factors of Jiangmen engineering plastics
2020-03-30 1336
Constrained formingIn constrained forming, the plasticizing, filling and curing reactions of materials are all carried out in the mold. In this process, three technical parameters, namely, mold temper
-
Analysis of Jiangmen engineering plastics what is ABS plastics
2020-02-27 1334
How about ABS plasticThe surface of this kind of plastic is mostly opaque ivory, and presents a granular state, and has a very high gloss. Its density can be said to be very high, even reaching about
-
What are the functional characteristics of PBT engineering plastics
2020-02-21 1303
PBT material. Pppetpbt not belonging to engineering plastics can become engineering plastics after being reinforced; For another example, after PA is reinforced with 30% glass fiber, its creep resista
-
Why PBT engineering plastics have poor heat hydrolysis resistance and Solutions
2020-01-16 1389
In the chemical industry, rubber and plastic industry, polyester is one of the commonly used rubber and plastic materials; And no matter what aspect of application, the functional requirements of rub